Here is today’s daily post from out Secrets of the Conceal Carry Snub.
If you note any typos or technical errors, please share them with me.
DAILY FUNCTION CHECK
Religiously confirming the firing status of your snub before slipping it into a pocket or holster is an invaluable self-defense habit. So too is developing the habit of conducting a daily function check. A quick daily function check will confirm that all the snub’s critical parts are clean, important screws are tight and the snub timing and lock up are correct. The following basic function check-list was suggested by Michael LaRocca of LaRocca’s Gun Works of Worcester, Massachusetts:
- Confirm Unloaded – Triple check that the revolver is clear and unloaded.
- Screws – Confirm that all exposed screws are tight. Locate the cylinder release. If the snub contains a cylinder release screw (not all snubs do) confirm that the screw is snug. If your snub includes a yoke screw (not all snubs do) confirm that the yoke screw is snug. Make a quick check of any other exposed screws. Also consider obtaining one or more dedicated screwdrivers of the correct sizes to avoid damaging the screws.
- Ejector Rod – Swing out the cylinder and confirm that the ejector rod is tight. Remember that some revolver models tighten clockwise, others tighten counter-clockwise, and still others are not threaded at all. Know which direction (if any) your snub’s ejector rod tightens before you check it.
- Star Ejector – Confirm that the underside of the star ejector is clean.
- Chambers – Confirm each and every one of the cylinder’s chambers is clean. A dedicated bore light can be an aid here.
- Barrel – Confirm that the barrel is clean and clear of any obstructions. Consider using either a dedicated bore light or a small piece of white paper to reflect light up from the forcing cone and down the bore.
- Cylinder – Close the unloaded cylinder and then confirm that the cylinder will rotate without binding.
- Lock up and End Shake – While the snub is still unloaded (!) dry fire the snub slowly and confirm that the cylinder is locking up properly. The cylinder stop (located on the flat bottom of the window of the frame directly under the cylinder) should lock into the cylinder stop notches at or just prior to the hammer releasing. After the hammer’s fall keep the trigger pulled to the rear. Then pinch the cylinder between your thumb and index finger. Note that there might be some very slight rocking movement of the cylinder (clockwise or counter-clockwise) in the window of the frame, but there should be close to no movement of the cylinder forward to the muzzle or rearward toward the recoil shield (end shake).
- Ammo – Before reloading the snub confirm that the ammo is new or like new (see reliable ammunition below).
- Again, always remember to conduct the daily function check with the unloaded snub and always keep the muzzle pointed in a safe direction. Consider obtaining a dedicated safe back stop such as a Safe Direction ballistic pad or an armor panel from a handgun rated piece of body armor
